BS 4500:2009 Limits and fits - Guidance for system of cone (taper) fits and tolerances for cones from C = 1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm
This British Standard gives guidance on a system of cone fits and
tolerances for cones from C = 1:3 to 1:500 and lengths from 6 mm
to 630 mm.
The appropriate tolerances of this British Standard can also be used
for prismatic workpieces, for example wedges.
This British Standard applies to cones which are dimensioned and
toleranced according to BS ISO 3040, Method 1, Basic Taper method.
This means that the tolerances limit the variation of penetration of
mating surfaces, each surface being within two limiting profiles of the
same taper corresponding to the maximum material condition (MMC)
and the least material condition (LMC).
This British Standard is derived from BS EN 20286, and is a complement
to BS EN ISO 1119.
NOTE For dimensioning and tolerancing cones on drawings, see
BS ISO 3040.
BS 4500:2009 Referenced Document
BS EN 20286-1 ISO system of limits and fits — Part 1 : Bases of tolerances, deviations and fits
BS 4500:2009 history
2009BS 4500:2009 Limits and fits - Guidance for system of cone (taper) fits and tolerances for cones from C = 1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm
1988BS 4500-5:1988 ISO limits and fits - Specification for system of cone tolerances for conical workpieces from C = 1:3 to 1:500 and lengths from 6 mm to 630 mm
1985BS 4500-4:1985 ISO limits and fits - Specification for system of cone (taper) fits for cones from C=1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm