DIN 6935:2010
Cold bending of flat rolled steel
- Standard No.
- DIN 6935:2010
- Release Date
- 2010
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN 6935:2011
- Latest
- DIN 6935:2011-10
- Scope
- This standard applies to bent components made from flat steel products for application in steel construction and general mechanical engineering. When bending flat rolled steel, such as sheets and plates, strips, wide flats etc., the rolling in direction should be considered, since bending should if possible be carried out transverse to the rolling direction owing to the greater suitability to bending offered. The bending suitability of the rolled steel shall be agreed with the manufacturer's works when ordering.
DIN 6935:2010 history
- 2011 DIN 6935:2011-10 Cold bending of flat rolled steel
- 2011 DIN 6935:2011 Cold bending of flat rolled steel
- 2010 DIN 6935:2010 Cold bending of flat rolled steel
- 1975 DIN 6935:1975 Cold Bending of Flat Rolled Steel Products
- 1970 DIN 6935:1969 Cold bending of flat rolled steel
- 1970 DIN 6935 Beiblatt 1:1967 Cold bending of flat rolled steel - Supplement 1: Factors determining the correction value <ypsilon> for calculating length of flats prior to bending
