DIN ISO 18653:2009
Gears - Evaluation of instruments for the measurement of individual gears (ISO 18653:2003)
- Standard No.
- DIN ISO 18653:2009
- Release Date
- 2009
- Published By
- German Institute for Standardization
- Status
- Replace By
- DIN ISO 18653:2009-12
- Latest
- DIN ISO 18653:2009-12
- Replace
- DIN ISO 18653:2007
- Scope
- This International Standard specifies methods for the evaluation of measuring instruments used for gear measurements of involute, helix, pitch and runout. The evaluation is based on the measurement of different kinds of calibrated artifacts. This standard describes also the necessary estimation of measurement uncertainty with the use of these artifacts.
DIN ISO 18653:2009 Referenced Document
- ISO 1328-1 Cylindrical gears.ISO system of flank tolerance classification.Part 1: Definitions and allowable values of deviations relevant to flanks of gear teeth*， 2013-09-01 Update
- ISO 14253-1 Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for verifying conformity or nonconformity with specifications*， 2017-10-01 Update
- ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories [Standard in French]*， 2017-11-01 Update
- ISO/TR 10064-3 Cylindrical gears - Code of inspection practice - Part 3: Recommendations relative to gear blanks, shaft centre distance and parallelism of axes; Technical Corrigendum 1
- ISO/TR 10064-5 Cylindrical gears - Code of inspection practice - Part 5: Recommendations relative to evaluation of gear measuring instruments; Technical Corrigendum 1
DIN ISO 18653:2009 history
- 2009 DIN ISO 18653:2009-12 Gears - Evaluation of instruments for the measurement of individual gears (ISO 18653:2003)
- 2009 DIN ISO 18653:2009 Gears - Evaluation of instruments for the measurement of individual gears (ISO 18653:2003)
- 0000 DIN ISO 18653:2007
