This International Standard specifies the general properties of coatings and test methods for coatings applied by dipping fabricated iron and steel articles (including certain castings) in a zinc melt (containing not more than 2 % of other metals). It does not apply to the following:
a) sheet, wire and woven or welded mesh products that are continuously hot dip galvanized;
b) tube and pipe that are hot dip galvanized in automatic plants;
c) hot dip galvanized products (e.g. fasteners) for which specific standards exist and which might include additional requirements or requirements which are different from those of this International Standard.
After-treatment/over-coating of hot dip galvanized articles is not covered by this International Standard.
EN 13283 Zinc and zinc alloys - Secondary zinc*, 2024-04-19 Update
ISO 10474 Steel and steel products - Inspection documents*, 2013-07-01 Update
ISO 1460 Metallic coatings — Hot dip galvanized coatings on ferrous materials — Determination of the mass per unit area — Gravimetric method*, 2020-09-14 Update
ISO 2064 Metallic and other inorganic coatings - Definitions and conventions concerning the measurement of thickness
ISO 2178 Non-magnetic coatings on magnetic substrates - Measurement of coating thickness - Magnetic method*, 2016-03-01 Update
ISO 2808 Paints and varnishes — Determination of film thickness*, 2019-07-26 Update
ISO 2859-1 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection; Technical Corrigendum 1
ISO 2859-2 Sampling procedures for inspection by attributes — Two-stage sampling plans for auditing and for inspection under prior information*, 2020-02-13 Update
ISO 2859-3 Sampling procedures for inspection by attributes - Part 3: Skip-lot sampling procedures
ISO 3549 Zinc dust pigments for paints*, 2024-01-01 Update
ISO 3882 Metallic and other inorganic coatings — Review of methods of measurement of thickness*, 2024-01-10 Update