EN ISO 15750-3:2008
Packaging - Steel drums - Part 3: Inserted flange-type closure systems
Home
EN ISO 15750-3:2008
Standard No.
EN ISO 15750-3:2008
Release Date
2008
Published By
European Committee for Standardization (CEN)
Status
Be replaced
2022-11
Replace By
EN ISO 15750-3:2022
Latest
EN ISO 15750-3:2022
Replace
BS ISO 15750-3:2002
Scope
This part of ISO 15750 specifies the characteristics, dimensions and finish of the inserted flange-type closuresystems used for steel drums.
EN ISO 15750-3:2008 Referenced Document
ISO 11949
Cold-reduced tinmill products - Electrolytic tinplate
*
,
2016-03-01 Update
ISO 11950
Cold-reduced tinmill products - Electrolytic chromium/chromium oxide-coated steel
*
,
2016-03-01 Update
ISO 228-1
Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation
ISO 228-2
Pipe threads where pressure-tight joints are not made on the threads; Part 2 : Verification by means of limit gauges
ISO 301
Zinc alloy ingots intended for castings
ISO 3573
Hot-rolled carbon steel sheet of commercial and drawing qualities
*
,
2012-12-01 Update
ISO 3574
Cold-reduced carbon steel sheet of commercial and drawing qualities
*
,
2012-12-01 Update
ISO 5002
Hot-rolled and cold-reduced electrolytic zinc-coated carbon steel sheet of commercial and drawing qualities
*
,
2013-11-01 Update
EN ISO 15750-3:2008 history
2022
EN ISO 15750-3:2022
Packaging - Steel drums - Part 3: Inserted flange-type closure systems (ISO 15750-3:2022)
2008
EN ISO 15750-3:2008
Packaging - Steel drums - Part 3: Inserted flange-type closure systems
Copyright ©2024 All Rights Reserved