ISO 14743:2004
Pneumatic fluid power - Push-in connectors for thermoplastic tubes
- Standard No.
- ISO 14743:2004
- Release Date
- 2004
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 14743:2020
- Latest
- ISO 14743:2020
- Scope
- This International Standard specifies the general requirements and test methods for the design and performance of push-in connectors for use with thermoplastic tubes with outside diameters of 3 mm to 12 mm, inclusive. This International Standard is intended to establish uniform methods of testing complete push-in connector assemblies as used in pneumatic fluid power applications. It is not applicable to air braking systems. NOTE In road vehicles, it is necessary to exercise special care to ensure that these connectors are never used in an air braking system.
ISO 14743:2004 Referenced Document
- ISO 16030 Pneumatic fluid power — Connections — Ports and stud ends*， 2022-07-15 Update
- ISO 1746 Rubber or plastics hoses and tubing - Bending tests
- ISO 4759-1:2000 Tolerances for fasteners - Part 1: Bolts, screws, studs and nuts - Product grades A, B and C
- ISO 5598 Fluid power systems and components — Vocabulary*， 2020-01-06 Update
- ISO 8573-1 Compressed air - Part 1: Contaminants and purity classes*， 2010-04-01 Update
ISO 14743:2004 history
- 2020 ISO 14743:2020 Pneumatic fluid power — Push-in connectors for thermoplastic tubes
- 2004 ISO 14743:2004 Pneumatic fluid power - Push-in connectors for thermoplastic tubes
