JIS C 5101-17:2009
Fixed capacitors for use in electronic equipment -- Part 17: Sectional specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors

Standard No.

JIS C 5101-17:2009

Release Date

2009

Published By

Japanese Industrial Standards Committee (JISC)

Status

Be replaced 2022-09

Replace By

JIS C 5101-17:2022

Latest

JIS C 5101-17:2022

Replace

JIS C 5101-17:2000

Scope

This Standard is a sectional specification associated with the generic specification JIS C 5101-1 and applies to fixed metallized polypropylene film dielectric a.c. and pulse capacitors for use in electronic equipment (hereafter referred to as "capacitors"). It covers fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment. NOTE 1 Capacitors which have mixed foil and metallized electrodes are also within the scope of this Standard. These capacitors may have "self-healing" properties depending on conditions of use. Capacitors covered by this Standard are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V. Capacitors for reactive power exceeding 500 var and to which a maximum peak voltage of 2 500 V at 50 Hz can be applied are not covered by this Standard, except when they are the highest part of a range of reactive power mainly situated below 500 var at 50 Hz. This Standard is not intended to cover capacitance values higher than 20 μF. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression are not included, but are covered by JIS C 5101-14. Capacitors for electrical shock hazard protection (covered by IEC 60065) and fluorescent lamp and motor capacitors are also excluded. NOTE 2 The International Standard corresponding to this Standard is as follows. IEC 60384-17 : 2005 Fixed capacitors for use in electronic equipment— Part 17: Sectional specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors (IDT) In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/IEC Guide 21.

JIS C 5101-17:2009 Referenced Document

• JIS C 5063:1997 Preferred number series for resistors and capacitors
• JIS C 5101-17-1:2009 Fixed capacitors for use in electronic equipment -- Part 17-1: Blank detail specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors -- Assessment levels E and EZ
• JIS C 5101-1:1998 Fixed capacitors for use in electronic equipment Part 1: Generic specification
• JIS C 60068-1:1993 Environmental testing Part 1: General and guidance
• JIS Z 8601:1954 Preferred numbers
• JIS Z 9015-1 Sampling procedures for inspection by attributes -- Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection

JIS C 5101-17:2009 history

• 2022 JIS C 5101-17:2022 Fixed capacitors for use in electronic equipment -- Part 17: Sectional specification -- Fixed metallized polypropylene film dielectric AC and pulse capacitors
• 2009 JIS C 5101-17:2009 Fixed capacitors for use in electronic equipment -- Part 17: Sectional specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors
• 2000 JIS C 5101-17:2000 Fixed capacitors for use in electronic equipment -- Part 17: Sectional specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors