AQ 3020-2008 Workshop fabricated steel tanks.Part 1: Horizontal cylindrical single skin and double skin tanks for the underground storage of flammable and non-flammable water polluting liquids (English Version)
This standard specifies the manufacturing requirements for underground horizontal circular single-layer and double-layer storage tanks for storing flammable and non-flammable liquids that pollute water within the following scope. ——The nominal diameter of the tank is 800mm~3000mm;
——The total length of the tank does not exceed 6 times the nominal diameter;
——The maximum density of the liquid stored is 1.9g/mL;
——The maximum working pressure (P: 0.15MPa (gauge pressure) ));
——For double-layer storage tanks using vacuum leakage detection systems, the dynamic viscosity of the liquid stored should be ≤5×10m/s. This standard applies to storage tanks under normal temperature (-20°C ~ +50°C) conditions. If the operating temperature of the storage tank exceeds this range, additional requirements should be considered. See Appendix B for the stored liquid-steel combination. This standard does not apply to the storage of liquids with special hazards described in Table 1. This standard does not cover internal coatings of storage tanks. Brief table
AQ 3020-2008 Referenced Document
EN 10025 Hot rolled products of non-alloy structural steels; technical delivery conditions
EN 10051:1991 Continuously Hot-Rolled Uncoated Plate, Sheet and Strip of Non-Alloy and Alloy Steels - Tolerances on Dimensions and Shape Incorporates Amendment 1; September 1997
EN 10204:1991 Metallic products; types of inspection documents
EN 13160-1 Leak detection systems - Part 1: General Principles*, 2016-07-01 Update
EN 13160-2 Leak detection systems - Part 2: Requirements and test/assessment methods for pressure and vacuum systems*, 2016-07-01 Update
EN 13160-3 Leak detection systems - Part 3: Requirements and test/assessment methods for liquid systems for tanks*, 2016-07-01 Update
EN 13160-4 Leak detection systems - Part 4: Requirements and test/assessment methods for sensor based leak detection systems*, 2016-07-01 Update
EN 13160-5 Leak detection systems - Part 5: Requirements and test/assessment methods for in-tank gauge systems and pressurised pipework systems*, 2016-07-01 Update
EN 13160-6 Leak detection systems - Part 6: Sensors in monitoring wells*, 2016-07-01 Update
EN 13160-7 Leak detection systems - Part 7: Requirements and test/assessment methods for interstitial spaces@ leak detection linings and leak detection jackets*, 2016-07-01 Update
EN 287-1 Qualification test of welders - Fusion welding - Part 1: Steels Incorporating Corrigendum August 2004; Includes Amendment A2:2006
EN 288-3 Specification and Approval of Welding Procedures for Metallic Materials - Part 3: Welding Procedure Tests for the Arc Welding of Steels Includes Amendment A1: 1997
EN ISO 8501-1 Preparation of steel substrates before application of paints and related products - Visual assessment of surface cleanliness - Part 1: Rust grades and preparation grades of uncoated steel substrates and of steel subtrates after overall removal of previous
EN ISO 898-1 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs with specified property classes - Coarse thread and fine pitch thread - Technical Corrigendum 1 (ISO 898-1:2013/Cor 1:2013)*, 2013-10-01 Update
AQ 3020-2008 history
2008AQ 3020-2008 Workshop fabricated steel tanks.Part 1: Horizontal cylindrical single skin and double skin tanks for the underground storage of flammable and non-flammable water polluting liquids