BS EN ISO 12004-2:2008
Metallic materials - Sheet and strip - Determination of forminglimit curves - Part 2: Determination of forming-limit curves in the laboratory

Standard No.

BS EN ISO 12004-2:2008

Release Date

2008

Published By

British Standards Institution (BSI)

Status

Be replaced 2021-03

Replace By

BS EN ISO 12004-2:2021

Latest

BS EN ISO 12004-2:2021

Replace

07/30150421 DC:2007

Scope

This part of ISO 12004 specifies the testing conditions to be used when constructing a forming-limit curve (FLC) at ambient temperature and using linear strain paths. The material considered is flat, metallic and of thickness between 0,3 mm and 4 mm. NOTE The limitation in thickness of up to 4 mm is proposed, giving a maximum allowable thickness to the punch diameter ratio. For steel sheet, a maximum thickness of 2.5 mm is recommended.

BS EN ISO 12004-2:2008 history

• 2021 BS EN ISO 12004-2:2021 Metallic materials. Determination of forming-limit curves for sheet and strip. Determination of forming-limit curves in the laboratory
• 2008 BS EN ISO 12004-2:2008 Metallic materials - Sheet and strip - Determination of forminglimit curves - Part 2: Determination of forming-limit curves in the laboratory