DIN EN ISO 6145-10:2008 PDF

Scope: This part of ISO 6145 specifies a dynamic method using permeation membranes for the preparation of calibration gas mixtures containing component mole fractions ranging from 10~ and 106. A relative expanded uncertainty of 2,5 % of the component mole fraction can be achieved using this method In the mole fraction range considered, it is difficult to maintain some gas mixtures, for example in cylinders, in a stable state It is therefore desirable to prepare the calibration gas immediately before use, and to transfer it by the shortest possible path to the place where it is to be used. This technique has been successfully applied in generating low content calibration gas mixtures of, for example, sulfur dioxide (SO2), nitrogen dioxide (NO2) and benzene (C6H6) in air. If the carrier gas flow is measured as a gas mass-flow, the preparation of calibration gas mixtures using permeation tubes is a dynamic-gravimetric method which gives contents in mole fractions.

DIN EN ISO 6145-10:2008 Referenced Document

ISO 6145-1 Gas analysis — Preparation of calibration gas mixtures using dynamic volumetric methods — Part 11: Electrochemical generation*， 2019-09-02 Update

2008 DIN EN ISO 6145-10:2008-11 Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 10: Permeation method (ISO 6145-10:2002); German version EN ISO 6145-10:2008
2008 DIN EN ISO 6145-10:2008 Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 10: Permeation method (ISO 6145-10:2002); English version of DIN EN ISO 6145-10:2008-11