EN ISO 5163:2005 Petroleum products - Determination of knock characteristics of motor and aviation fuels - Motor method [Superseded: CEN EN 25163] [Use: IP 236/2005]
This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary
scale of octane numbers using a standard single-cylinder, four-stroke cycle, variable-compression ratio,
carburetted, CFR engine operated at constant speed. Motor octane number (MON) provides a measure of the
knock characteristics of motor fuels in automotive engines under severe conditions of operation. The motor
octane number provides a measure of the knock characteristics of aviation fuels in aviation piston engines, by
using an equation to correlate to aviation-method octane number or performance number (lean-mixture
aviation rating).
This International Standard is applicable for the entire scale range from 0 MON to 120 MON, but the working
range is 40 MON to 120 MON. Typical motor fuel testing is in the range of 80 MON to 90 MON. Typical
aviation fuel testing is in the range of 98 MON to 102 MON.
This International Standard can be used for oxygenate-containing fuels containing up to 4,0 % (m/m) oxygen.
Certain gases and fumes, such as halogenated refrigerants used in air-conditioning equipment that can be
present in the area where the CFR engine is located, may have a measurable effect on the MON rating.
Electrical power transient voltage or frequency surges or distortion can affect MON ratings.
NOTE 1 This International Standard specifies operating conditions in SI units but engine measurements are specified
in inch-pound units because these are the units used in the manufacture of the equipment, and thus some references in
this International Standard include these units in parenthesis.
NOTE 2 For the purposes of this International Standard, the expressions “% (m/m)” and “% (V/V)” are used to represent
the mass and volume fractions of a material, respectively.
EN ISO 5163:2005 history
2014EN ISO 5163:2014 Petroleum products - Determination of knock characteristics of motor and aviation fuels - Motor method (ISO 5163:2014)
2005EN ISO 5163:2005 Petroleum products - Determination of knock characteristics of motor and aviation fuels - Motor method [Superseded: CEN EN 25163] [Use: IP 236/2005]