EN 60519-3:2005 Safety in electroheat installations Part 3: Particular requirements for induction and conduction heating and induction melting installations
European Committee for Electrotechnical Standardization（CENELEC）
Latest
EN 60519-3:2005
Replace
EN 60519-3-1995
Scope
This part of IEC 60519 is applicable to
– installations for induction and conduction heating of solids, at low, mains, medium and
high frequencies (for conduction heating, use of direct current is also included);
– installations for induction melting, holding and superheating liquid metal at low, mains,
medium and high frequencies;
– those parts of the conveying or handling equipment of the electroheat installation which
are within the influence of the heating section.
Examples of application are:
– installations for induction and conduction heating of slabs, billets, rods, strip, wire, tubes,
rivets, etc. for subsequent hot forming and heat treatment;
– installations with induction crucible furnaces or induction channel furnaces.
This standard consists of requirements common to both induction and conduction heating
installations and induction melting installations (Clauses 1 to 14) and specific requirements for
induction and conduction heating installations (Annex A) and specific requirements for
induction melting installations (Annex B).
EN 60519-3:2005 history
2005EN 60519-3:2005 Safety in electroheat installations Part 3: Particular requirements for induction and conduction heating and induction melting installations
1995EN 60519-3:1995 Safety in Electroheat Installations Part 3: Particular Requirements for Induction and Conduction Heating and Induction Melting Installations