For the purposes of determining compliance with the specified limits for properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E 29
1.1 This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.
1.2 Seven groups of stainless steel alloys are covered, including ten austenitic, two ferritic, four martensitic, and one precipitation hardening.
| Group | AlloysA | ConditionB | |
|---|---|---|---|
| 1 | 304, 305, 304L 384, 18–9LW, 302HQC | (CW) | cold workedD |
| 2 | 316, 316L | (CW) | cold workedD |
| 3 | 321, 347 | (CW) | cold workedD |
| 4 | 430E | (CW) | cold workedD |
| 5 | 410F | (H) | hardened and tempered |
| 6 | 431 | (H) | hardened and tempered |
| 7 | 630 | (AH) | aged hardened |
A Unless otherwise specified on the inquiry and order, the choice of an alloy from within a group shall be at the discretion of the fastener manufacturer (see 6.1).
B See 4.2 for options.
C When approved by the purchaser, alloys 303, 303Se, or XM1 may be furnished.
D Sizes 0.75 in. and larger may be hot worked and solution annealed.
E When approved by the purchaser, alloy 430F may be furnished.
F When approved by the purchaser, alloy 416 or 416Se may be furnished.
1.3 Supplementary requirements of an optional nature are provided, applicable only when agreed upon by the manufacturer and the purchaser at the time of the inquiry and order.
1.4 Suitable bolts, hex cap screws, and studs for use with nuts included in this specification are covered by Specification......
Copyright ©2024 All Rights Reserved