EN ISO 293:2005
Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2004)
- Standard No.
- EN ISO 293:2005
- Release Date
- 2005
- Published By
- European Committee for Standardization (CEN)
- Status
- 2023-06
- Replace By
- EN ISO 293:2023
- Latest
- EN ISO 293:2023
- Scope
- This International Standard specifies the general principles and the procedures to be followed with thermoplastics in the preparation of compression-moulded test specimens,and sheets from which test specimens may be machined or stamped.In order to obtain mouldings in a reproducible state,the main steps of the procedure,including four different cooling methods,are standardized.For each material,the required moulding temperature and cooling methods are as specified in the appropriate International Standard for the material or as agreed between the interested parties.The procedure is not recommended for reinforced thermoplastics.
EN ISO 293:2005 history
- 2023 EN ISO 293:2023 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2023)
- 2005 EN ISO 293:2005 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2004)
- 2003 EN ISO 293:2003 Plastics - Compression moulding test specimens of thermoplastic materials ISO 293: 1986
