This European Standard specifies the requirements for the corrosion resistance of building hardware for doors, windows, shutters and curtain walling.This European Standard provides a method of classification of corrosion resistance of building hardware based on performance in a neutral salt spray test (EN ISO 9227).This European Standard specifies requirements for both coated and uncoated surfaces and five grades of corrosion resistance being laid down in accordance with the different conditions of use grades 1 to 5. A grade 0 is also included for which no requirements have been specified. Requirements for levels of corrosion resistance which are higher than those laid down for grade 5 have not been included inThis European Standard and are subject to agreement where required.This European Standard also applies to the metal fasteners required for fixing building hardware if specified. Screws and fastenings which are sold with a hardware product which conforms toThis European Standard should also conform toThis European Standard. NOTE 1 The term "grade" used inThis European Standard corresponds to the term "class" which is used in ISO standards. NOTE 2 There is seldom a direct relationship between resistance to the action of salt spray and resistance to corrosion in other media, because several factors influencing the progress of corrosion, such as the formation of protective films, vary greatly with the conditions encountered. Therefore, the test results should not be regarded as a direct guide to the corrosion resistance of the tested materials in all environments where these materials may be used. Also, the performance of different materials during the test should not be taken as a direct guide to the corrosion resistance of these materials in service. The method described inThis European Standard gives a means of checking that the comparative quality of a material, with or without corrosion protection, is maintained. In addition, for quality control purposes, comparison can be made between specimens coated with the same coating. As comparative tests, however, salt spray tests are only suitable if the coatings are sufficiently similar in nature. It is often not possible to use results gained from salt spray testing as a comparative guide to the long-term behaviour of different coating systems as the corrosion stress during these tests differs significantly from the corrosion stresses encountered in practice.
EN 1670:2007 history
2007EN 1670:2007 Building hardware - Corrosion resistance - Requirements and test methods
1998EN 1670:1998 Building Hardware - Corrosion Resistance - Requirements and Test Methods