1.1 This test method covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins.
1.2 The properties included in this test method are those required for the compositions covered. It is possible that other requirements will be necessary to identify particular characteristics important to specialized applications. These shall be agreed upon between the user and the supplier, by using the suffixes as given in Section 5.
1.3 This test method does not allow for the use of recycled plastics (as defined in Guide D 5033).
1.4 The values stated in inch-pound units are regarded as standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1 and Table S-PEI.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no similar or equivalent ISO standard.
Copyright ©2024 All Rights Reserved