ASTM E1399-97(2000)
Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems

Standard No.

ASTM E1399-97(2000)

Release Date

1997

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM E1399-97(2005)

Latest

ASTM E1399/E1399M-97(2022)

Scope

1.1 This test method covers testing procedures for architectural joint systems. This test method is intended for the following uses:

1.1.1 To verify movement capability information supplied to the user by the producer,

1.1.2 To standardize comparison of movement capability by relating it to specified nominal joint widths.

1.1.3 To determine the cyclic movement capability between specified minimum and maximum joint widths without visual deleterious effects, and

1.1.4 To provide the user with graphic information, drawings or pictures in the test report, depicting them at minimum, maximum, and nominal joint widths during cycling.

1.2 This test method is intended to be used only as part of a specification or acceptance criterion due to the limited movements tested.

1.3 The acceptable standard units of measure are SI units and the equivalent inch-pound units are expressed in parenthesis.

1.4 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM E1399-97(2000) history

• 2022 ASTM E1399/E1399M-97(2022) Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
• 2017 ASTM E1399/E1399M-97(2017) Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
• 2013 ASTM E1399/E1399M-97(2013)e1 Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
• 1997 ASTM E1399-97(2009) Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
• 1997 ASTM E1399-97(2005) Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
• 1997 ASTM E1399-97(2000) Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems