ASTM D3715/D3715M-98(2004)
Standard Practice for Quality Assurance of Pressure-Sensitive Tapes
- Standard No.
- ASTM D3715/D3715M-98(2004)
- Release Date
- 1998
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D3715/D3715M-98(2011)
- Latest
- ASTM D3715/D3715M-98(2019)
- Scope
1.1 This practice contains uniform quality assurance provisions for pressure-sensitive tapes and establishes sampling plans and procedures for acceptance inspection.
1.2 Limitations
1.2.1 This practice only includes procedures for when an upper or a lower specification limit is given. It does not provide for double, both minimum and maximum, specification limits. Note 1When double specification limits are given (applies to variables testing only), use may be made of Table C-3 and Example C-3 of ANSI/ASQC Z1.9.
1.2.2 The variables sampling plans apply to a single quality characteristic. Having obtained the sample and the responses to the physical property tests, acceptance is determined on one quality characteristic at a time. The process is repeated for each additional characteristic.
1.2.3 The variables sampling plans require that the response to each quality characteristic is normally distributed either directly or by transformation. If this is not known, the potential user of this practice should seek the counsel of someone with sufficient understanding of statistical techniques to provide that information.
1.3 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D3715/D3715M-98(2004) Referenced Document
- ANSI/ASQC Z1.9 Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming*， 2003-12-18 Update
- ASTM D996 Standard Terminology of Packaging and Distribution Environments*， 1999-04-19 Update
ASTM D3715/D3715M-98(2004) history
- 2019 ASTM D3715/D3715M-98(2019) Standard Practice for Quality Assurance of Pressure-Sensitive Tapes
- 1998 ASTM D3715/D3715M-98(2011) Standard Practice for Quality Assurance of Pressure-Sensitive Tapes
- 1998 ASTM D3715/D3715M-98(2004) Standard Practice for Quality Assurance of Pressure-Sensitive Tapes
- 1998 ASTM D3715/D3715M-98 Standard Practice for Quality Assurance of Pressure-Sensitive Tapes
