This test method provides an accurate and reliable method to measure the total calorific value of a fuel gas, on a continuous basis, which is used for regulatory compliance, custody transfer, and process control.
1.1 This test method covers the determination with the continuous recording calorimeter (Note 1) of the total calorific (heating) value of fuel gas produced or sold in the natural gas range from 900 to 1200 Btu/standard ft3.
Note 18212;An extensive investigation of the accuracy of the Cutler-Hammer recording gas calorimeter, when used with gases of high heating value, was made by the National Bureau of Standards in 1957 under a research project sponsored by the American Gas Association.
1.2 The subjects covered in this test method appear in the following sections:
| Sections | |
| Air-Gas Ratio Test | 11 |
| Apparatus | 5 |
| Basis of Measurement | 14 |
| Cold Balance Test | 10 |
| Compensation of Complicating Factors | 13 |
| Condition of Gas Sample | 7 |
| Definitions | 2 |
| Installation of Apparatus | 6 |
| Maintenance | Appendix X1 |
| Operating Precautions | Appendix X2 |
| Operation and Checking of Apparatus | 9 |
| Precision | 15 |
| Scope | 1 |
| Significance and Use | 4 |
| Standardization of Calorimeter | 12 |
| Standardization, Preliminary, of Calorimeter by Hydrogen | 8 |
| Summary of Test Method | 3 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Copyright ©2024 All Rights Reserved