ASTM D1476-02(2007)
Standard Test Method for Heptane Miscibility of Lacquer Solvents

Standard No.
ASTM D1476-02(2007)
Release Date
2002
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D1476-02(2012)
Latest
ASTM D1476-02(2012)
Scope

Water in a solvent may interfere with many uses of the solvent. This test method provides a measure of the miscibility of lacquer solvents with a nonpolar medium-heptane. It also provides a qualitative indication of the presence or absence of moisture in these solvents (often esters and ketones). The results of these measurements may be used for specification acceptance.

1.1 This test method covers determination of the miscibility of lacquer solvents with heptane. It may also be used to detect qualitatively the presence of moisture in esters and ketones. Note 1 - For the quantitative determination of water content, see Test Method D 1364.

<>

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

ASTM D1476-02(2007) Referenced Document

  • ASTM D1364 Standard Test Method for Water in Volatile Solvents (Karl Fischer Reagent Titration Method)
  • ASTM D611 Standard Test Methods for Aniline Point and Mixed Aniline Point of Petroleum Products and Hydrocarbon Solvents

ASTM D1476-02(2007) history

Standard Test Method for Heptane Miscibility of Lacquer Solvents


Copyright ©2024 All Rights Reserved