The removal of volatile materials such as gasoline dilution from used engine oils is especially important if the mechanical shear stability or oxidative stability of the oil is being monitored by measuring a kinematic viscosity change in the oil after it has been used in a gasoline engine.
1.1 This test method covers a standardized procedure for removing volatile materials such as gasoline and water from used engine oils prior to further oil analysis.
1.2 It also provides an estimate of such volatiles in used engine oils.
1.3 When an accurate value of the gasoline contaminant is required either Test Methods D 322 or D 3525 shall be used.
Note 18212;Test Method D 322 determines the amount of gasoline by distillation with water. Test Method D 3525 determines the amount of material boiling below the boiling point of n-tetradecane by gas chromatography.
Note 28212;When the amount of gasoline is required to be known, the user of this test method is advised to determine which method is to be used. There are cases where D 3525 may be set as the referee method.
1.4 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statement, see 6.1 and 8.5.
Copyright ©2024 All Rights Reserved