ASTM F1002-06
Standard Performance Specification for Protective Clothing for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- Standard No.
- ASTM F1002-06
- Release Date
- 2006
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM F1002-13
- Latest
- ASTM F1002-15(2021)
- Scope
1.1 This performance specification covers textile materials to be used for protective clothing.
1.2 Materials used for both primary protection and for secondary protection are covered.
1.3 Protective properties relate to contact with molten substances and hot surfaces, and exposure to open flame and radiant heat.
1.4 This performance specification covers clothing design characteristics that relate to the unique protective requirements of working with molten substances.
1.5 This performance specification describes the properties of specific textile materials in their fabric or garment composite form as tested by laboratory methods and is not intended to be used to appraise the thermal hazard or fire risk under actual conditions. However, information on the thermal performance of clothing made from textile materials conforming to this specification may be used as an element in thermal risk assessment which takes into account all factors pertinent to the thermal hazard of a particular end use.
1.6 The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.
The following precautionary caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F1002-06 Referenced Document
- ASTM D1424 Standard Test Method for Tearing Strength of Fabrics by Falling-Pendulum Type (Elmendorf) Apparatus
- ASTM D2262
- ASTM D2724 Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- ASTM D4157 Standard Test Method for Abrasion Resistance of Textile Fabrics (Oscillatory Cylinder Method)
- ASTM D5034 Standard Test Method for Breaking Strength and Elongation of Textile Fabrics (Grab Test)
- ASTM D6413 Standard Test Method for Flame Resistance of Textiles (Vertical Test)
- ASTM F955 Standard Test Method for Evaluating Heat Transfer through Materials for Protective Clothing Upon Contact with Molten Substances
ASTM F1002-06 history
- 2021 ASTM F1002-15(2021) Standard Performance Specification for Protective Clothing and Materials for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 2015 ASTM F1002-15 Standard Performance Specification for Protective Clothing and Materials for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 2014 ASTM F1002-14 Standard Performance Specification for Protective Clothing and Materials for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 2013 ASTM F1002-13 Standard Performance Specification for Protective Clothing and the Materials from Which It Is Made for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 2006 ASTM F1002-06 Standard Performance Specification for Protective Clothing for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 2005 ASTM F1002-05 Standard Performance Specification for Protective Clothing for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
- 1996 ASTM F1002-96 Standard Performance Specification for Protective Clothing for Use by Workers Exposed to Specific Molten Substances and Related Thermal Hazards
