ASTM D5540-94a(1999)
Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis

Standard No.

ASTM D5540-94a(1999)

Release Date

1994

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5540-94a(2003)

Latest

ASTM D5540-13(2021)

Scope

1.1 This practice covers the conditioning of a flowing water sample for the precise measurement of various chemical and physical parameters of the water, whether continuous or grab. This practice addresses the conditioning of both high- and low-temperature and pressure sample streams, whether from steam or water.

1.2 This practice provides procedures for the precise control of sample flow rate to minimize changes of the measured variable(s) due to flow changes.

1.3 This practice provides procedures for the precise control of sample temperature to minimize changes of the measured variable(s) due to temperature changes.

1.4 The values stated in either SI or inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5540-94a(1999) history

• 2021 ASTM D5540-13(2021) Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis
• 2013 ASTM D5540-13 Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis
• 2008 ASTM D5540-08 Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis
• 1994 ASTM D5540-94a(2003) Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis
• 1994 ASTM D5540-94a(1999) Standard Practice for Flow Control and Temperature Control for On-Line Water Sampling and Analysis