These test methods are designed for use in most cases with the actual equipment to be used in load handling.
These test methods may be used in evaluating the shipping unit as to suitability for mechanical handling by standard user-specified load-handling equipment.
These test methods will allow the user to determine integrity and stability of the load as well as provide guidance to improve the design of the unit load where deficiencies are found.
Damage to products or packages observed during testing may be expected to correlate at least in a qualitative way to damage observed in actual distribution handling systems.
1.1 These test methods are suitable for testing the integrity of unitized loads and large cases and crates, but not individual drums or palletized drums, as well as the ability of the contents to endure normal handling, using standard mechanical handling equipment. Not all of the test methods are applicable to all products containers and loads. These test methods are applicable to common means of material handling, including pull pack, clamp truck, and spade lift-type handling equipment as follows:
1.1.1 Test Method A8212;Fork Truck Handling8212;For testing the ability of the shipping unit to withstand repeated handlings by this test method.
1.1.2 Test Method B8212;Spade Lift Test8212;For lifting by spade lift attachment to determine the ability of the handling flap of the case or shipping unit to withstand repeated lifting and handling by this test method.
1.1.3 Test Method C8212;Clamp Handling Test8212;For lifting by hydraulic clamp attachment, to determine the ability of the shipping unit to withstand squeeze clamp handling consisting of repeated side compression and lifting.
1.1.4 Test Method D8212;Push-Pull Handling Test8212;For testing the ability of a unitized load on a slip-sheet to withstand repeated handling by this test method.
1.1.5 Test Method E8212;Grabhook Test8212;For lifting by grabhooks to determine the ability of the shipping unit to withstand the horizontal pressures of grabhooks.
1.1.6 Test Method F8212;Sling Tests8212;For lifting by wire rope, cable, or woven fiber slings to determine the ability of the shipping unit to withstand the compression of slings.
1.2 Additional Test Methods:
1.2.1 Additional test methods that apply to mechanical handling and rough handling tests of unitized loads and large cases and crates include incline impact tests, described in Test Method D 880; horizontal impact tests, described in Test Method D 4003.
1.2.2 Practice D 4169 provides a series of options for selecting and running performance tests on all types of shipping containers and systems.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Copyright ©2024 All Rights Reserved