ASTM E390-95
Standard Reference Radiographs for Steel Fusion Welds

Standard No.

ASTM E390-95

Release Date

1995

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM E390-01

Latest

ASTM E390-20

Scope

1.1 This standard provides reference radiographs for steel fusion welds that contain typical discontinuities with varying severity levels in different thicknesses of material.

1.2 There are three volumes of reference radiographs based on seven nominal weld thicknesses as follows:

Vol I8212;Set of 16 plates (81/2 by 11 in.) covering base material up to and including 1/4 in. (6.4 mm) in thickness.

Vol II8212;Set of 29 plates (81/2 by 11 in.) covering base material over 1/4 to and including 3 in. (6.4 to 76 mm) in thickness.

Vol III8212;Set of 32 plates (81/2 by 11 in.) covering base material over 3 to including 8 in. (76 to 203 mm) in thickness.

1.3 The values stated in inch-pound units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM E390-95 history

• 2020 ASTM E390-20 Standard Reference Radiographs for Steel Fusion Welds
• 2015 ASTM E390-15 Standard Reference Radiographs for Steel Fusion Welds
• 2011 ASTM E390-11 Standard Reference Radiographs for Steel Fusion Welds
• 2001 ASTM E390-01(2006)e1 Standard Reference Radiographs for Steel Fusion Welds
• 2001 ASTM E390-01 Standard Reference Radiographs for Steel Fusion Welds
• 1995 ASTM E390-95 Standard Reference Radiographs for Steel Fusion Welds