ASTM D5736-95(2001)
Standard Test Method for Thickness of Highloft Nonwoven Fabrics
- Standard No.
- ASTM D5736-95(2001)
- Release Date
- 1995
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- 2008-10
- Latest
- ASTM D5736-95(2001)
- Scope
This test method is used in the trade for acceptance testing of commercial shipments; however, comparative tests as directed in 5.1.1 may be advisable.
5.1.1 In case of a dispute arising from differences in reported test results when using this test method for acceptance testing of commercial shipments of nonwoven fabrics, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. Test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using the appropriate studentrsquo; t-test and an acceptable probability level chosen by the two parties before testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results with consideration to the known bias.
Thickness is one of the basic physical properties of highloft nonwoven fabrics. In certain industrial applications, the thickness may require rigid control within specified limits. Bulk and warmth properties of highloft nonwoven fabrics are often estimated from their thickness values, and thickness is also useful in measuring performance characteristics, such as before and after abrasion or shrinkage.
The thickness value of highloft nonwoven fabrics will vary considerably depending on the pressure applied to the specimen at the time the thickness measurement is taken. In all cases, the apparent thickness varies inversely with the pressure applied. For this reason, it is essential that the pressure be specified when discussing or listing any thickness value.
1.1 This test method describes the measurement of thickness of highloft nonwoven fabrics. For thickness of nonwoven fabrics other than highloft, see Test Method D5729.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D5736-95(2001) Referenced Document
- ASTM D123 Standard Terminology Relating to Textiles*， 2023-09-14 Update
- ASTM D1776 Standard Practice for Conditioning and Testing Textiles*， 1998-04-19 Update
- ASTM D1777 Standard Test Method for Thickness of Textile Materials*， 2019-07-01 Update
- ASTM D2904 Standard Practice for Interlaboratory Testing of a Textile Test Method that Produces Normally Distributed Data *， 1997-04-19 Update
- ASTM D5729 Standard Test Method for Thickness of Nonwoven Fabrics *， 1997-04-19 Update
ASTM D5736-95(2001) history
- 1995 ASTM D5736-95(2001) Standard Test Method for Thickness of Highloft Nonwoven Fabrics
- 1995 ASTM D5736-95 Standard Test Method for Thickness of Highloft Nonwoven Fabrics
