ASTM D4188-82(2003)
Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test
- Standard No.
- ASTM D4188-82(2003)
- Release Date
- 1982
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D4188-08
- Latest
- ASTM D4188-17
- Scope
Pressure in-line coagulation-flocculation followed by filtration is an effective process to remove suspended and colloidal matter from water and waste water.
The effectiveness of this process is dependent on the type and concentration of the flocculant or coagulant, or both, the pH, the temperature, the filtration medium(a), and the filtration rate. This practice permits the evaluation of these various parameters.
This practice can also be used to determine filter backwash and rinse requirements.
The results obtained from this practice can be used for plant design of large systems.
1.1 This practice covers the procedure used to perform pressure in-line coagulation-flocculation-filtration of water and waste water. It is applicable to water and waste water with relatively low suspended solids (< 30 mg/L). The practice is applicable for any size filter greater than 100 mm (4 in.) in diameter.
1.2 This practice can be used to determine the effectiveness of flocculants or coagulants, or both, and filter medium(a) in removing suspended and colloidal material from water and waste water.
1.3 Interval between filter backwashing, backwash requirements, rinse requirements, and effect of filtration rate on effluent quality can also be obtained with this practice.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D4188-82(2003) Referenced Document
- ASTM D1129 Standard Terminology Relating to Water*， 1999-04-19 Update
- ASTM D1888 Methods of Test for Particulate and Dissolved Matter in Water
- ASTM D1889 Standard Test Method for Turbidity of Water*， 2000-01-01 Update
- ASTM D2035 Standard Practice for Coagulation-Flocculation Jar Test of Water
- ASTM D3370 Standard Practices for Sampling Water from Closed Conduits*， 1995-09-10 Update
- ASTM D4187
- ASTM D4189 Standard Test Method for Silt Density Index (SDI) of Water*， 1995-04-19 Update
ASTM D4188-82(2003) history
- 2017 ASTM D4188-17 Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water
- 2013 ASTM D4188-13 Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water
- 2008 ASTM D4188-08 Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test
- 1982 ASTM D4188-82(2003) Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test
- 1999 ASTM D4188-82(1999) Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test
