ASTM D5948-05e1
Standard Specification for Molding Compounds, Thermosetting

Standard No.

ASTM D5948-05e1

Release Date

2005

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5948-05(2012)

Latest

ASTM D5948-05(2020)

Scope

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).

ResinPhenolic, cellulose filledPhenolic, mineral/glass filledMelaminePolyesterDiallyl iso-phthalateDiallyl ortho-phthalateSiliconeEpoxy

Note 18212;There is no equivalent ISO standard.

1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

ASTM D5948-05e1 history

• 2020 ASTM D5948-05(2020) Standard Specification for Molding Compounds, Thermosetting
• 2005 ASTM D5948-05(2012) Standard Specification for Molding Compounds, Thermosetting
• 2005 ASTM D5948-05e1 Standard Specification for Molding Compounds, Thermosetting
• 2005 ASTM D5948-05 Standard Specification for Molding Compounds, Thermosetting
• 1996 ASTM D5948-96(2002)e1 Standard Specification for Molding Compounds, Thermosetting