This standard sets minimum requirements for shop‑ and field‑applied,
liquid‑epoxy interior linings and exterior coatings used in the water‑supply industry
for steel water pipelines installed underground or underwater, under normal
construction conditions.
1.1.1 Conditions not described in this standard. The coating systems described
in this standard are not intended for use on pipe that will be bent after the
coating or lining system has been applied.
1.1.2 Coating and lining systems. The coating and lining systems may
consist of any of the following three types: (1) a two‑part, chemically cured epoxy
primer and one or more coats of a different two‑part, chemically cured epoxy topcoat;
(2) two or more coats of the same two‑part, chemically cured epoxy coating,
in which case the first coat shall be considered as the prime coat; or (3) a single coat
of a two‑part, chemically cured epoxy coating.
Maximum temperature. AWWA steel pipe coating standards ar1.1.2.1 e
based on the maximum service temperature of water. The purchaser shall consult
the coating manufacturer for conditions and limitations.
AWWA C210-2007 Referenced Document
ANSI/AWWA C203 Coal-Tar Protective Coatings and Linings for Steel Water Pipe*， 2020-10-26 Update
ANSI/AWWA C209 Tape Coatings for Steel Water Pipe and Fittings*， 2019-12-01 Update
ANSI/AWWA C214 Machine-Applied Polyolefin Tape Coatings for Steel Water Pipe*， 2020-10-26 Update
ANSI/AWWA C215 Extruded Polyolefin Coatings for Steel Water Pipe*， 2022-10-01 Update
ANSI/AWWA C216 Heat-Shrinkable Cross-Linked Polyolefin Coatings for Steel Water Pipe and Fittings*， 2023-02-01 Update
ANSI/AWWA C217 Microcrystalline Wax and Petrolatum Tape Coating Systems for Steel Water Pipe and Fittings*， 2023-06-01 Update
ANSI/AWWA C222 Polyurethane Coatings and Linings for Steel Water Pipe and Fittings*， 2018-05-01 Update
ASTM D3359 Standard Test Methods for Measuring Adhesion by Tape Test
ASTM D3363 Standard Test Method for Film Hardness by Pencil Test*， 2022-06-01 Update
ASTM D4417 Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel
ASTM D4541 Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM D4752 Standard Test Method for Measuring MEK Resistance of Ethyl Silicate (Inorganic) Zinc-Rich Primers by Solvent Rub
ASTM G8 Standard Test Methods for Cathodic Disbonding of Pipeline Coatings*， 2019-06-01 Update
NACE RP0188 Discontinuity (Holiday) Testing of New Protective Coatings on Conductive Substrates
AWWA C210-2007 history
2015AWWA C210-2015 Liquid-Epoxy Coatings and Linings for Steel Water Pipe and Fittings
2007AWWA C210-2007 Liquid-Epoxy Coating Systems for the Interior and Exterior of Steel Water Pipelines
2003AWWA C210-2003 Liquid-Epoxy Coating Systems for the Interior and Exterior of Steel Water Pipelines
1997AWWA C210-1997 Liquid-Epoxy Coating Systems for the Interior and Exterior of Steel Water Pipelines