SIS SS-ISO 2857:1990 Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion
This International Standard specifies the manufacturing tolerances on the threaded portion of taps for producing the ISO metric threads of tolerance classes 4H to 8H and 4G to 6G as defined in ISO/R 965/1 to III (excluding, consequently, classes 7G and 8G considered as usually produced with ground thread taps).
Swedish comment:
The text within the parenthesis should read: "______
considered as usually not produced with ground taps."
It is valid for the short taps specified in ISO/R 529 as well as for any other kind of ground thread taps with the same diameters and pitches.
The internal threads produced with those taps are conventionally designated by the simplified denomination of "nut" in agreement with the word used in ISO/R 965 for the general designation of all internal threads.
Swedish comment:
This applies only to the English text. The Swedish version uses the well established term "internal threads".
Annexes A and B give, for all threads with coarse and fine pitches, the manufacturing tolerances on the threaded portion of taps for the following classes of nuts :
4H and 5H - 6H - 7H and 8H
and 4G and 5G - 6G
SIS SS-ISO 2857:1990 history
1990SIS SS-ISO 2857:1990 Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion