BS EN 1007-6:2007 PDF

Scope: This European Standard specifies the conditions for measurement of tensile properties a of single filament of ceramic fibres at high temperatures in air or inert atmosphere (vacuum or controlled atmosphere). The method applies to continuous ceramic filaments taken from tows, yarns, staple fibre, braids and knitting, that have strain to fracture less than or equal to 5 % and show linear elastic behaviour to fracture. The method does not apply to testing for homogeneity of strength properties of fibres, nor does it assess the effects of volume under stress. Statistical aspects of fibre failure are not included. Two methods are proposed depending on the temperature of the filament end:  Hot end method: this method allows determination of tensile strength, of Young's modulus and of the stress strain curve. NOTE 1 Current experience with this technique is limited to 1 300 °C, because of the application temperature of ceramic glue.  Cold end method. NOTE 2 This method is limited to 1 700 °C in air and 2 000 °C in inert atmosphere because of the limits of furnaces.

BS EN 1007-6:2007 Referenced Document

EN 1007-3 Advanced technical ceramics - Ceramic composites; Methods of test for reinforcement - Part 3: Determination of filament diameter and cross-section area
EN 1007-4 Advanced technical ceramics - Ceramic composites - Methods of test for reinforcement - Part 4: Determination of tensile properties of filaments at ambient temperature
EN 60584-1 Thermocouples - Part 1: EMF specifications and tolerances*， 2024-04-18 Update
EN 60584-2 Thermocouples Part 2: Tolerances (Remains Current)
EN ISO 7500-1 Metallic materials - Verification of static uniaxial testing machines - Part 1: Tension/compression testing machines - Verification and calibration of the force-measuring system
EN ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories*， 2017-12-01 Update

2008 BS EN 1007-6:2008 Advanced technical ceramic - Ceramic composites - Methods of test for reinforcements - Determination of tensile properties of filaments at high temperature
2008 BS EN 1007-6:2007 Advanced technical ceramic - Ceramic composites - Methods of test for reinforcements - Part 6: Determination of tensile properties of filaments at high temperature