DIN EN ISO 18595:2007 PDF

Standard No.: DIN EN ISO 18595:2007
Release Date: 2007
Published By: German Institute for Standardization
Status: Be replaced
Replace By: DIN EN ISO 18595 E:2020
Latest: DIN EN ISO 18595 E:2020; DIN EN ISO 18595:2020; DIN EN ISO 18595:2021-05
Replace: DIN EN ISO 18595:2006

Scope: This International Standard specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm. This International Standard is applicable to the welding of sheets or plates of dissimilar thickness where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses where the total thickness is less than or equal to 9 mm. Welding with the following types of machines is within the scope of this International Standard: -- pedestal welding machines; O -- gun welders; -- automatic welding equipment where the components are fed by robots or automatic feeding equipment; -- multi-welders; -- robotic welders. Information on appropriate welding equipment is given in Annex A and on spot welding conditions in Annex B. The latter are for guidance only and may require modification depending on service conditions of the fabrication, type of welding equipment, characteristics of the secondary circuit, electrode material and geometry. The welding of coated material, e.g. zinc-coated or anodised material, is not within the scope of this International Standard.

DIN EN ISO 18595:2007 Referenced Document

ISO 10447 Resistance welding — Testing of welds — Peel and chisel testing of resistance spot and projection welds*， 2022-11-25 Update
ISO 14329:2003 Resistance welding - Destructive tests of welds - Failure types and geometric measurements for resistance spot, seam, and projection welds
ISO 5182 Resistance welding - Materials for electrodes and ancillary equipment*， 2016-08-01 Update
ISO 5184 Straight resistance spot welding electrodes
ISO 5821 Resistance welding - Spot welding electrode caps*， 2009-02-01 Update
ISO 5830 Resistance spot welding; Male electrode caps
ISO 669:2000 Resistance welding - Resistance welding equipment - Mechanical and electrical requirements

2021 DIN EN ISO 18595:2021 Resistance welding - Spot welding of aluminium and aluminium alloys - Weldability, welding and testing (ISO 18595:2021); German version EN ISO 18595:2021
1970 DIN EN ISO 18595 E:2020-03 Spot weldability, welding and testing of resistance welded aluminum and aluminum alloys (draft)
2020 DIN EN ISO 18595 E:2020 Draft Document - Resistance welding - Spot welding of aluminium and aluminium alloys - Weldability, welding and testing (ISO/DIS 18595:2020); German and English version prEN ISO 18595:2020
2007 DIN EN ISO 18595:2007 Resistance welding - Spot welding of aluminium and aluminium alloys - Weldability, welding and testing (ISO 18595:2007); English version of DIN EN ISO 18595:2007-12
0000 DIN EN ISO 18595:2006