JB/T 10801.2-2007 (English Version) PDF

Scope: This part of JB/T 10801 specifies the basic requirements for the design, manufacture and acceptance of electric spindles for machining centers. This section applies to electric spindles used in machining centers (hereinafter referred to as electric spindles).

JB/T 10801.2-2007 Referenced Document

GB 755-2000 Rotating electrical machines-Rating and performance
GB/T 10069.1-2006 Measurement of airborne noise emitted by rotating electrical machines and the noise limits Part 1: Method for the measurement of airborne noise emitted by rotating electrical machines
GB/T 1032-2005 Test procedures for three-phase induction motors
GB/T 13574-1992 Metal-cutting machine tools--Test code for static rigidity
GB/T 16768-1997 Metal-cutting machine tools--Measurement method for vibration
GB/T 16769-1997 Metal-cutting machine tools--Measurement method of sound pressure level
GB/T 17421.1-1998 Test code for machine tools. Part 1: Geometric accuracy of machines operating under no-load or finishing conditions
JB/T 10273-2001 General specification for A.C. spindle motors
JB/T 9615.1-2000 Test methods of the interturn insulation on random wound winding for AC low-voltage machines
JB/T 9615.2-2000 Test Limits of the interturn insulation on random wound winding for AC low-voltage machines

2007 JB/T 10801.2-2007 High-frequency spindie.Part 2: Specigcations for high-frequency SPindle used in madining centres