IEC 60728-4:2007 Cable networks for television signals, sound signals and interactive services - Part 4: Passive wideband equipment for coaxial cable networks (TA 5)
This part of IEC 60728 applies to system outlets, splitters and taps, passive single or multiple
port equipment comprising filters, attenuators, equalizers, galvanic isolators, power injectors,
cable splices, terminating resistors and transfer points, but excluding coaxial cables and
receiver leads (see 5.2).
This standard
• covers the frequency range 5 MHz to 3 000 MHz;
• identifies performance requirements for certain parameters;
• lays down data publication requirements for certain parameters;
• stipulates methods of measurements;
• introduces minimum requirements defining quality grades.
There are three grades for all passive equipment except system outlets where there is only
one.
Different networks require the same performance and, when integrating networks, upgrading
will be avoided.
Practical experience has shown that these three grades meet most of the technical
requirements necessary for supplying a minimum signal quality to the subscribers. This
classification should not be considered as a requirement but as information for users and
manufacturers on the minimum quality criteria of the material required to install networks of
different sizes. The system operator should select appropriate material to meet the minimum
signal quality at the subscriber's outlet and to optimize cost/performance, taking into account
the size of the network and local circumstances.
All requirements and published data should be understood as guaranteed values within the
specified frequency range and in well-matched conditions.
IEC 60728-4:2007 Referenced Document
IEC 60068 Basic climatic and mechanical robustness testing procedure for components
IEC 60728 Cabled distribution systems primarily intended for sound and television signals operating between 30 MHz and 1 GHz
IEC 60966-1 Radio frequency and coaxial cable assemblies - Part 1: Generic specification - General requirements and test methods*, 2019-02-08 Update
IEC 60966-2-4 Radio frequency and coaxial cable assemblies - Part 2-4: Detail specification for cable assemblies for radio and TV receivers - Frequency range 0 MHz to 3000 MHz, IEC 61169-2 connectors*, 2016-05-01 Update
IEC 60966-2-5 Radio frequency and coaxial cable assemblies - Part 2-5: Detail specification for cable assemblies for radio and TV receivers - Frequency range 0 MHz to 1000 MHz, IEC 61169-2 connectors*, 2016-10-01 Update
IEC 60966-2-6 Radio frequency and coaxial cable assemblies - Part 2-6: Detail specification for cable assemblies for radio and TV receivers - Frequency range 0 MHz to 3000 MHz, IEC 61169-24 connectors*, 2016-10-01 Update
IEC 61000-4-5 Electromagnetic compatibility (EMC) - Part 4-5: Testing and measurement techniques - Surge immunity test*, 2024-04-18 Update
IEC 61000-6-1 Electromagnetic compatibility (EMC) - Part 6-1: Generic standards - Immunity standard for residential, commercial and light-industrial environments*, 2016-08-10 Update
IEC 61169-1 Radio frequency connectors – Part 1: Generic specification – General requirements and measuring methods (Edition 2.0)*, 2016-02-01 Update
IEC 61169-2 Radio-frequency connectors - Part 2: Sectional specification - Radio frequency coaxial connectors of type 9,52
IEC 60728-4:2007 history
2007IEC 60728-4:2007 Cable networks for television signals, sound signals and interactive services - Part 4: Passive wideband equipment for coaxial cable networks (TA 5)
2000IEC 60728-4:2000 Cabled distribution systems for television and sound signals - Part 4: Passive coaxial wideband distribution equipment
1997IEC 60728-4:1997 Cabled distribution systems for television and sound signals - Part 4: Passive coaxial wideband distribution equipment