BS EN 3061:2007 Aerospace series - Bearings, airframe rolling - Rigid single row ball bearings in corrosion resisting steel, with flanged alignment housing - Dimensions and loads
This standard specifies the characteristics of rigid single row ball bearings in corrosion resisting steel with a
solid or lightweight flanged alignment housing, designed to withstand only slow rotations and slight oscillations
under load.
They are intended for use in the hubs of torsion lever and in separated supports for airframe/aerospace
applications.
The airframe rolling bearings defined in this standard may be used in the temperature range from – 54 °C to
150 °C.
However, being lubricated with the following greases (see EN 3727):
- ester type very high pressure grease (code letter A), operating range from – 73 °C to 121 °C or,
- synthetic hydrocarbons type very high pressure grease general purpose (code letter B) operating range
from – 54 °C to 177 °C.
Their field of application when lubricated with code letter A grease is limited to 121 °C.
BS EN 3061:2007 Referenced Document
EN 2030 Aerospace series - Steel X105CrMo17 (1.3544) - Hardened and tempered - Bars - De = 150 mm*, 2024-04-18 Update
EN 2226 Aerospace series - Steel X105CrMo17 (1.4125) - Hardened and tempered - Hand and die forgings - De ��150 mm*, 2014-07-01 Update
EN 2424 Aerospace series - Marking of aerospace products*, 2008-05-01 Update
EN 3161 Aerospace series - Steel FE-PM3801 (X5CrNiCu17-4) - Air melted, solution treated and precipitation treated, bar a or D Less than or equval to 200 mm, Rm Greater than or equval to 930 MPa*, 2007-08-01 Update
EN 3727 Aerospace series - Bearings, airframe rolling rigid with flanged alignment housing - Technical specification
ISO 1132-1 Rolling bearings - Tolerances - Part 1: Terms and definitions
ISO 8075 Aerospace; Surface treatment of hardenable stainless steel parts
BS EN 3061:2007 history
2007BS EN 3061:2007 Aerospace series - Bearings, airframe rolling - Rigid single row ball bearings in corrosion resisting steel, with flanged alignment housing - Dimensions and loads