ISO 8062-3:2007
Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings

Standard No.
ISO 8062-3:2007
Release Date
2007
Published By
International Organization for Standardization (ISO)
Status
Replace By
ISO 8062-3:2007/cor 1:2009
Latest
ISO 8062-3:2023
Scope
This part of ISO 8062 specifies general dimensional and geometrical tolerances, as well as machining allowance grades, for castings as delivered to the purchaser in accordance with ISO 8062-2. It is applicable for the tolerancing of dimensions and geometry, and required machining allowance of castings in all cast metals and their alloys produced by various casting manufacturing processes. This part of ISO 8062 applies to both general dimensional and general geometrical tolerances (referred to in or near the title block of the drawing), unless otherwise specified, and where specifically referred to on the drawing by one of the references in Clause 9. The dimensional tolerances covered by this part of ISO 8062 are tolerances for linear dimensions. The geometrical tolerances covered by this part of ISO 8062 are: - tolerances for straightness, - flatness, - roundness, - parallelism, - perpendicularity, - symmetry, and - coaxiality. This part of ISO 8062 can be used for the selection of tolerance values for individual indications. NOTE This part of ISO 8062 does not apply to 3D CAD models used without indicated dimensions.

ISO 8062-3:2007 Referenced Document

  • ISO 10579:1993 Technical drawings; dimensioning and tolerancing; non-rigid parts
  • ISO 1101:2004 Geometrical Product Specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
  • ISO 1302:2002 Geometrical Product Specifications (GPS) - Indication of surface texture in technical product documentation
  • ISO 14405 Geometrical product specifications (GPS) — Dimensional tolerancing — Part 3: Angular sizes*2016-12-13 Update
  • ISO 286-1:1988 ISO system of limits and fits; part 1: bases of tolerances, deviations and fits
  • ISO 5459 Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems — Amendment 1
  • ISO 8062-1:2007 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 1: Vocabulary
  • ISO/TS 8062-2 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 2: Rules*2013-07-01 Update

ISO 8062-3:2007 history

  • 2023 ISO 8062-3:2023 Geometrical product specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 3: General dimensional and geometrical tolerances and machining allowances for castings using ± tolerances for indicated dimensions
  • 2009 ISO 8062-3:2007/cor 1:2009 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings; Technical Corrigendum 1
  • 2007 ISO 8062-3:2007 Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings
Geometrical product specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 3: General dimensional and geometrical tolerances and machining allowances for castings



Copyright ©2024 All Rights Reserved