ISO 15901-3:2007 Pore size distribution and porosity of solid materials by mercury porosimetry and gas adsorption - Part 3: Analysis of micropores by gas adsorption
International Organization for Standardization (ISO)
Latest
ISO 15901-3:2007
Scope
This part of ISO 15901 describes methods for the evaluation of the volume of micropores (pores of internal
width less than 2 nm) and the specific surface area of microporous material by low-temperature adsorption of
gases [1],[2],[3],[4],[5],[6],[7]. These are comparative, non-destructive tests. The methods use physisorbing gases
that can penetrate into the pores under investigation. The method is applicable to isotherms of type I, II, IV or
VI of the IUPAC classification (see ISO 15901-2:—, Figure 1, and ISO 9277).
The methods in this part of ISO 15901 are not applicable when chemisorption or absorption takes place.
ISO 15901-3:2007 Referenced Document
ISO 3165 Sampling of chemical products for industrial use; Safety in sampling
ISO 8213 Chemical products for industrial use; Sampling techniques; Solid chemical products in the form of particles varying from powders to coarse lumps
ISO 9277:1995 Determination of the specific surface area of solids by gas adsorption using the BET method
ISO 15901-3:2007 history
2007ISO 15901-3:2007 Pore size distribution and porosity of solid materials by mercury porosimetry and gas adsorption - Part 3: Analysis of micropores by gas adsorption