IEC 60603-7-5:2007
Connectors for electronic equipment - Part 7-5: Detail specification for 8-way, shielded, free and fixed connectors, for data transmissions with frequencies up to 250 MHz

Standard No.

IEC 60603-7-5:2007

Release Date

2007

Published By

International Electrotechnical Commission (IEC)

Status

Be replaced 2010-04

Replace By

IEC 60603-7-5:2010

Latest

IEC 60603-7-5:2010

Scope

This part of IEC 60603-7 covers IEC 60603-7-5 connectors, and specifies mechanical and environmental requirements, and electrical transmission requirements for frequencies up to 250 MHz. These connectors are typically used as category 6 connectors in class E cabling systems specified in ISO/IEC 11801:2002. These connectors are intermateable, interoperable, and backward compatible with other IEC 60603-7 series connectors. While the definition of interoperable is being discussed within IEC, “interoperable” in this standard means the following: The fixed and the free connector are capable of interconnecting with any IEC 60603-7 series connector, and that when it is interconnected, it fully meets all requirements of the lower frequency IEC 60603-7 series standard. NOTE Transmission performance categories: in this part of IEC 60603-7, the term “category”, when used in reference to transmission performance, refers to those categories defined by ISO/IEC 11801:2002.

IEC 60603-7-5:2007 history

• 2010 IEC 60603-7-5:2010 Connectors for electronic equipment - Part 7-5: Detail specification for 8-way, shielded, free and fixed connectors, for data transmission with frequencies up to 250 MHz
• 2007 IEC 60603-7-5:2007 Connectors for electronic equipment - Part 7-5: Detail specification for 8-way, shielded, free and fixed connectors, for data transmissions with frequencies up to 250 MHz

IEC 60603-7-5:2007 Connectors for electronic equipment - Part 7-5: Detail specification for 8-way, shielded, free and fixed connectors, for data transmissions with frequencies up to 250 MHz was changed to IEC 60512-26-100:2008 Connectors for electronic equipment - Tests and measurements - Part 26-100: Measurement setup, test and reference arrangements and measurements for connectors according to IEC 60603-7 - Tests 26a to 26g.