This European Standard specifies the requirements for periodic inspection and testing of seamless steel transportable gas cylinders (single or those from bundles) intended for compressed and liquefied gases under pressure, of water capacity from 0,5 1 up to 150 1.
NOTE As far as practicable, this standard may also be applied to cylinders of less than 0,51 water capacity.
This standard specifies the requirements for periodic inspection and testing to verify the integrity of such gas cylinders to be reintroduced into service for a further period of time. It also defines a procedure to qualify existing gas cylinders for free movement between member states of the European Union (see annex A).
This standard does not apply to periodic inspection and testing of acetylene cylinders or composite (fully wrapped or hoop-wrapped) steel cylinders.
BS EN 1968:2002 Referenced Document
EN 1089-1 Transportable Gas Cylinders - Gas Cylinder Identification (Excluding LPG) - Part 1: Stampmarking
EN 473 Non-destructive testing - Qualification and certification of NDT personnel - General principles*, 2008-06-01 Update
EN 629-2 Transportable Gas Cylinders - 25E Taper Thread for Connection of Valves to Gas Cylinders - Part 2: Gauge Inspection
EN 837-1 Pressure gauges - Part 1: Bourdon tube pressure gauges - Dimensions, metrology, requirements and testing
EN 837-3 Pressure gauges - Part 3: Diaphragm and capsule pressure gauges - Dimensions, metrology, requirements and testing
BS EN 1968:2002 history
1970BS EN 1968:2002+A1:2005 Transportable gas cylinders — Periodic inspection and testing ofseamless steel gas cylinders
2002BS EN 1968:2002 Transportable gas cylinders - Periodic inspection and testing of seamless steel gas cylinders