IEC 61462:2007
Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1000 V - Definitions, test methods, acceptance criteria and design recommendations
- Standard No.
- IEC 61462:2007
- Release Date
- 2007
- Published By
- International Electrotechnical Commission (IEC)
- Status
- 2023-09
- Replace By
- IEC 61462:2023
- Latest
- IEC 61462:2023
- Replace
- IEC 36C/167/FDIS:2006 IEC/TR2 61462:1998
- Scope
- This International Standard applies to composite hollow insulators consisting of a load-bearing insulating tube made of resin impregnated fibres, a housing (outside the insulating tube) made of elastomeric material (for example silicone or ethylene-propylene) and metal fixing devices at the ends of the insulating tube. Composite hollow insulators as defined in this standard are intended for general use (unpressurized) or for use with a permanent gas pressure (pressurized). They are intended for use in both outdoor and indoor electrical equipment operating on alternating current with a rated voltage greater than 1 000 V and a frequency not greater than 100 Hz or for use in direct current equipment with a rated voltage greater than 1 500 V.
IEC 61462:2007 history
- 2023 IEC 61462:2023 Composite hollow insulators. Pressurized and unpressurized insulators for use in electrical equipment with AC rated voltage greater than 1 000 V AC and D.C. voltage greater than 1500V. Definitions, test methods, acceptance criteria and design…
- 2007 IEC 61462:2007 Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1000 V - Definitions, test methods, acceptance criteria and design recommendations
