This standard is applicable to heat shrinkable moulded shapes in a range of configurations
and materials suitable for insulation, environmental sealing, mechanical protection and strain
relief for connector/cable terminations and multi-way transitions. It specifies the design and
dimensions, test methods, material requirements and compatibility performance. The most
commonly available shapes are as shown in Annex A.
Materials which conform to this specification meet established levels of performance.
However, the selection of a material by a user for a specific application should be based on
the actual requirements necessary for adequate performance in that application and not
based on this specification alone.
BS EN 62329-1:2006 history
0000 BS EN 62329-1:2006(2007)
2006BS EN 62329-1:2006 Heat shrinkable moulded shapes - Definitions and general requirements