ISO 16063-12:2002
Methods for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method
- Standard No.
- ISO 16063-12:2002
- Release Date
- 2002
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 16063-12:2002/Cor 1:2008
- Latest
- ISO 16063-12:2002/Cor 1:2008
- Scope
- This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units.
It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency-dependent amplitude range of 10m/s
to 100 m/s and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer. Calibration of the sensitivity of a transducer can be obtained using this part of ISO 16063 provided that the signal conditioner or amplifier used with the transducer during calibration has been adequately characterized. In order to achieve the uncertainties of measurement given in clause 3, it has been assumed that the transducer has been calibrated in combination with its signal conditioner or amplifier (the combination of which in this part of ISO 16063 is referred to as the "accelerometer").
ISO 16063-12:2002 history
- 2008 ISO 16063-12:2002/Cor 1:2008 Methods for the calibration of vibration and shock transducers — Part 12: Primary vibration calibration by the reciprocity method — Technical Corrigendum 1
- 2002 ISO 16063-12:2002 Methods for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method
