This part of ISO 294 specifies two two-cavity moulds, the type D1 and D2 ISO moulds, for the injection moulding of
small plates measuring 60 mm × 60 mm with a preferred thickness of 1 mm (type D1) or 2 mm (type D2), which can
be used for a variety of tests. The moulds may additionally be fitted with inserts for studying the effects of weld
lines on the mechanical properties (see annex A).
EN ISO 294-3:2003 Referenced Document
ISO 294-1:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens
ISO 294-4:2001 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage
ISO 6603-1:2000 Plastics - Determination of puncture impact behaviour of rigid plastics - Part 1: Non-instrumented impact testing
ISO 6603-2:2000 Plastics - Determination of puncture impact behaviour of rigid plastics - Part 2: Instrumented impact testing
EN ISO 294-3:2003 history
2020EN ISO 294-3:2020 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates (ISO 294-3:2020)
2003EN ISO 294-3:2003 Plastics - Injection Moulding of Test Specimens of Thermoplastic Materials - Part 3: Small Plates ISO 294-3: 2002
1998EN ISO 294-3:1998 Plastics - Injection Moulding of Test Specimens of Thermoplastic Materials - Part 3: Small Plates ISO 294-3:1996