EN 13598-1:2003
Plastics piping systems for non-pressure underground drainage and sewerage - Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - Part 1: Specifications for ancillary fittings including shallow inspection chambers
- Standard No.
- EN 13598-1:2003
- Release Date
- 2003
- Published By
- European Committee for Standardization (CEN)
- Status
- Replace By
- EN 13598-1:2010
- Latest
- EN 13598-1:2010
- Scope
- This European Standard specifies the definitions and requirements for ancillary fittings of unplasticized poly(vinyl chloride) (PVC-U); polypropylene (PP); and polyethylene (PE) intended to be used in non-pressure underground drainage and sewerage systems; conforming to EN 476: a) outside the building structure (application area code "U"); reflected in the marking of products by "U"; and b) both buried in ground within the building structure (application area code "D") and outside the building structure (application area code "U"); reflected in the marking of products by "UD". It also specifies the test parameters for the test methods referred inThis standard. The ancillary fittings covered byThis standard are the following: sealed access fittings; rodding point covers; rodding tees; mechanical saddles; inspection chambers for shallow non-roadway applications to a maximum depth of 1;25 m. NOTE 1 Inspection chambers as defined in 6.1.3 of EN 476:1997 have a riser with a DN/ID less than 800 mm. NOTE 2 Deep inspection chambers and manholes for application area U are specified in Part 2 of this standard. The fittings can be manufactured by various methods e. g. injection moulding; rotational moulding; spiral winding or fabricated from components made to other standards. The jointing can be with: elastomeric ring seal joint; cemented joint for PVC-U; welded joint for PP and PE. NOTE 3 Pipes; fittings and other components conforming to any of the plastics products standards listed in Clause 2 can be used with ancillary fittings conforming toThis standard; provided they conform to the requirements for joint dimensions given in Clause 6 and to the requirements of Table 6.
EN 13598-1:2003 history
- 2010 EN 13598-1:2010 Plastics piping systems for non-pressure underground drainage and sewerage - Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - Part 1: Specifications for ancillary fittings including shallow inspection chambers
- 2003 EN 13598-1:2003 Plastics piping systems for non-pressure underground drainage and sewerage - Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - Part 1: Specifications for ancillary fittings including shallow inspection chambers
