This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150mm or 6 in incluslve, having specified minimum tensile strengths of 900 MPa or 120000 psi and greater, which are primarily intended for use in automotive assemblies.1.1 The basic recommended practice does not include inspection sampling requirements. It is intended that the purchaser shall specify, in the original inquiry and purchase order, the inspection sampling requirements which the producer must satisfy to demonstrate the acceptability of bolts and screws with respect to surface discontinuities.
2013SAE J1062-2013 HOLDER@ ELECTRICAL CARD@ METAL CARD GUIDE@ LOW PROFILE@ CLOSED ENDED@ WITH FLARED ENTRY@ WITH THREE MOUNTING HOLES@ FOR VERSAMODULE EUROCARD APPLICATIONS