SAE AS5168A-2003 PDF

Scope: FITTING, PLUG, TUBE END, FLAREDTABLE 1A - DIMENSIONSTABLE 1B - DIMENSIONS AND WEIGHTS

SAE AS5168A-2003 Referenced Document

ASME B46.1-2002 Surface texture (surface roughness, waviness, and lay)*， 2024-04-18 Update
ASME Y14.36M-1996 Surface Texture Symbols
ASME Y14.5M-1994 Dimensioning and tolerancing
ASTM A108-03 Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished*， 2024-04-18 Update
ASTM A108-99 Standard Specification for Steel Bars, Carbon, Cold-Finished, Standard Quality
SAE AMS2486C-2001 CONVERSION COATING OF TITANIUM ALLOYS Fluoride-Phosphate Type
SAE AMS2488D-2000 (R) Anodic Treatment - Titanium and Titanium Alloys Solution pH 13 or Higher
SAE AMS4112 ALUMINUM ALLOY BARS, ROLLED, DRAWN, OR COLD FINISHED 4.5Cu - 1.5Mg - 0.60Mn (2024-T6)
SAE AMS4124C-1997 Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire 5.6Zn - 2.5Mg - 1.6Cu - 0.23Cr (7075-T7351) Solution Heat Treated, Stress Relieved by Stretching, and Overaged UNS A97075
SAE AMS4928Q-2001 Titanium Alloy Bars, Wire, Forgings, and Rings 6Al 4V Annealed
SAE AMS5639H-2002 Steel@ Corrosion-Resistant@ Bars@ Wire@ Forgings@ Tubing@ and Rings 19Cr - 10Ni Solution Heat Treated (UNS S30400)
SAE AMS5645P-2001 Steel, Corrosion and Heat Resistant, Bars, Wire, Forgings, Tubing, and Rings 18Cr - 10Ni - 0.40Ti (SAE 30321) Solution Heat Treated UNS S32100

2020 SAE AS5168C-2020 FITTING, PLUG, TUBE END, FLARED
2019 SAE AS5168B-2019 FITTING, PLUG, TUBE END, FLARED
2015 SAE AS5168A-2015 FITTING, PLUG, TUBE END, FLARED
2003 SAE AS5168A-2003 FITTING, PLUG, TUBE END, FLARED
1998 SAE AS5168-1998 Fitting@ Plug@ Tube End@ Flared (FSC 4730; Should Be Used Instead of the Following Two Flared Fitting Standards@ Which Were Cancelled on 28 September 1999: AN806 REV 7 and MS24404E)