DIN EN 12666-1:2006 Plastics piping systems for non-pressure underground drainage and sewerage - Polyethylene (PE) - Part 1: Specifications for pipes, fittings and the system; English version of DIN EN 12666-1:2006-03
This Part of EN 12666 specifies the requirements for pipes, fittings and the system of polyethylene (PE/piping
systems intended to be used for
non-pressure underground drainage and sewerage outside the building structure (application area code
"U"'). and
non pressure underground drainage and sewerage for both buried in the ground within the building
structure (application area code "D") and outside the building structure.
This is reflected in the marking of products by "U" and "UD".
It also specifies the test parameters for the test methods referred to in this European Standard.
This European Standard covers a range of nominal sizes, a range of pipe series/stiffness classes and gives
recommendations concerning colours.
NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects,
taking into account their particular requirements and any relevant national regulations and installation practices or codes.
In conjunction with CEN/TS 12666-2 M] it is applicable to PE pipes and fittings, their joints and to joints with
components of other plastics and non-plastics materials intended to be used for buried piping systems for
non-pressure drainage and sewerage.
This European Standard is applicable to PE pipes with or without an integral socket.
The fittings can be manufactured by injection-moulding or be fabricated from pipes and/or mouldings.
-I"his European Standard is applicable to PE pipes and fittings for the following types of joints:
elastomeric ring seal joints;
butt fused joints;
-- electrofusion joints;
mechanical joints.
NOTE 2 Requirements and limiting values for application area code "D" are given in Tables 3, 6 and Table 12.
NOTE 3 Pipes, fittings and other components conforming to any of the plastics product standards listed in the
bibliography may be used with pipes and fittings conforming to this European Standard, provided they conform to the
requirements for joint dimensions given in Clause 6 and to the requirements of Table 8 and Table 12.
DIN EN 12666-1:2006 history
2016DIN EN 1501-1:2016 Refuse collection vehicles - General requirements and safety requirements - Part 1: Rear loaded refuse collection vehicles; German version EN 1501-1:2011+A1:2015
2011DIN EN 12666-1:2011 Plastics piping systems for non-pressure underground drainage and sewerage - Polyethylene (PE) - Part 1: Specifications for pipes, fittings and the system; German version EN 12666-1:2005+A1:2011
2006DIN EN 12666-1:2006 Plastics piping systems for non-pressure underground drainage and sewerage - Polyethylene (PE) - Part 1: Specifications for pipes, fittings and the system; English version of DIN EN 12666-1:2006-03
1970DIN EN 12666-1 E:1997-02 Plastics piping systems for non-pressure underground drainage and sewerage - Polyethylene (PE) - Part 1: Specifications for pipes, fittings and the system