This standard specifies methods commonly used for the passivation of corrosion-resistant stainless steel fasteners. The typical anode dissolution behavior of active-passive metals is shown in the appendix. Note: The corresponding international standards for this standard are shown below. The symbols representing the degree of correspondence are IDT (matched), MOD (modified), and NEQ (not equivalent) based on ISO/IEC Guide 21.
JIS B 1047:2006 Referenced Document
JIS B 1054-1 Mechanical properties of corrosion-resistant stainless steel fasteners .Part 1: Bolts, screws and studs*， 2013-05-20 Update
JIS B 1054-2 Mechanical properties of corrosion-resistant stainless steel fasteners .Part 2: Nuts*， 2013-05-20 Update
JIS B 1054-3 Mechanical properties of corrosion-resistant stainless steel fasteners -- Part 3: Set screws and similar fasteners not under tensile stress*， 2013-05-20 Update
JIS B 1054-4 Mechanical properties of corrosion-resistant stainless steel fasteners .Part 4: Tapping screws*， 2013-05-20 Update
JIS B 1047:2006 history
2006JIS B 1047:2006 Passivation of corrosion-resistant stainless-steel fasteners