This specification covers an aluminum alloy in the form of flat sheet and plate 0.500 inch (12.70 mm) and under in nominal thickness. Primarily for structural parts requiring a combination of good strength and maximum corrosion resistance. These products, when re-solution heat treated by the user, may not have the tensile properties shown. Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking; ARP 823 recommends practices to minimize such conditions.
SAE AMS4195C-2002 Referenced Document
ASTM B660-02 Standard Practices for Packaging/Packing of Aluminum and Magnesium Products*, 2024-04-18 Update
ASTM B660-96 Standard Practices for Packaging/Packing of Aluminum and Magnesium Products
SAE AMS2202 Tolerances Aluminum Alloy and Magnesium Alloy Sheet and Plate
SAE AMS2355 TENSILE TESTING OF WROUGHT ALUMINUM AND MAGNESIUM PRODUCTS Except Forgings
SAE AMS2355F-1992 Quality Assurance Sampling and Testing of Aluminum Alloys and Magnesium Alloys Wrought Products@ Except Forging Stock@ and Rolled@ Forged@ or Flash Welded Rings
SAE ARP823D-1997 Minimizing Stress-Corrosion in Wrought Heat-Treatable Aluminum Alloy Products
SAE MAM2202 TOLERANCES, METRIC Aluminum Alloy and Magnesium Alloy Sheet and Plate
SAE MAM2355 QUALITY ASSURANCE SAMPLING AND TESTING OF ALUMINUM ALLOYS AND MAGNESIUM ALLOYS Wrought Products (Except Forging Stock) and Flash Welded Rings Metric (SI) Units