This part of EN 755 specifies the tolerances on dimensions and form for aluminium and aluminium alloy extruded profile with a cross section contained within a circumscribing circle not greater than 800 mm (see Figure 1).
This standard applies to extruded profiles for general engineering applications only.
The tolerances in this standard only apply to those dimensions that can be physically measured.
NOTE Some of the products listed in the present standard can be subject to patent or patent applications, and their listing herein does not in any way imply the granting of a licence under such patent right.
CEN/TC 132 affirms it is its policy that in the case when a patentee refuses to grant licences on standardised standard products under reasonable and not discriminatory conditions, then this product shall be removed from the corresponding standard.
Dimensions in millimetres
BS EN 755-9:2001 history
2016BS EN 755-9:2016 Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles. Profiles, tolerances on dimensions and form
2008BS EN 755-9:2008 Aluminium and aluminium alloys — Extruded rod/bar, tube and profiles — Part 9: Profiles, tolerances on dimensions and form
2001BS EN 755-9:2001 Aluminium and aluminium alloys - Extruded rod/bar, tube and profiles - Profiles, tolerances on dimensions and form